Installation Guide

5. Setting Up Windows Server 2008 (32-bit)
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
236
Chapter 1 Installing Windows
Note
When the message below appears, select Yes.
"The selected team will be deleted from system, do you want to
proceed?
NOTE:
A
pplying the changes will temporarily interrupt the
n
etwork connection. The process may take several
minutes and the connection will resume afterwards."
3. Insert EXPRESSBUILDER DVD into the optical disk drive.
If the Autorun Menu appears, close the menu.
Tips
You do not have to insert EXPRESSBUILDER DVD if Starter Pack was installed
from Internal Flash Memory. Proceed to the next step.
4. Double-click addlvlanstats.vbs in the following folder.
− When using EXPRESSBUILDER DVD:
Optical disk drive:\001\win\winnt\ws2008\lan\bcom\ws2008x86\lan
− If Starter Pack was installed from Internal Flash Memory:
System drive:\StartPKG\ws2008\lan\bcom\ws2008x86\lan
5. When the following message appears, click OK.
6. Eject EXPRESSBUILDER DVD from the optical disk drive, and then restart the system.
Team deletion is now complete.
5.5.4
Setting up team (PROSet)
(1) Team types
The following team types are supported.
 Adapter Fault Tolerance (AFT) is a feature that creates a group containing and automatically converts
the process of the working adapter to the other adapter in the group when any trouble occurred on that
adapter.
 Adaptive Load Balancing (ALB) is a feature that creates a group containing more than one adapter and
enhances the throughput by operating packet transmission from the server by all the adapters. This
feature includes AFT feature.
 Switch Fault Tolerance (SFT) is a feature that provides a failover relationship between two ports when
each port is connected to a separate switch. SFT supports two ports per team.
 Static Link Aggregation (SLA) accounts for the GEC and 802.3ad static protocols. SLA is a
switch-assisted teaming mode and requires configuring ports at both ends of the link: server interfaces
and switch ports.