Installation Guide

5. Setting Up Windows Server 2008 (32-bit)
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
208
Chapter 1 Installing Windows
22. When the following message appears, select the installation type.
Select Custom (advanced) in this case.
23. "Where do you want to install Windows?" window appears.
Note
If the driver was loaded in steps 17 and 18, or if a RAID Controller is not used, go to
step 27.
Click Load Driver.
If the following message appears, replace the OS installation media and EXPRESSBUILDER DVD in
the optical disk drive, and then click Browse. Next, go to step 24.
Load Driver
To install the driver needed to access your hard drive, insert
the installation media containing the driver files
,
and then
click OK.
Note: The installation media can be a floppy disk, CD, DVD, or
USB flash drive.
Browse OK Cancel
Tips
• If using Internal Flash Memory, you do not need to remove the OS installation
media.
• At this time, the message "The Installation media can be a floppy disk, CD,
DVD, or USB flash drive." appears on the screen, use the supplied
EXPRESSBUILDER DVD or Internal Flash Memory.
24. Specify one of the following locations, and then click OK.
(When using EXPRESSBUILDER, select the optical disk drive. When using Internal Flash Memory,
select the volume of INTER-FLASH.)
When using the N8103-149/150/151 RAID Controller:
\001\win\winnt\oemfd\ws2008\megasas2
When using the N8103-152 RAID Controller: