Installation Guide

4. Setting Up Windows Server 2008 R2
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
158
Chapter 1 Installing Windows
1. Open the Device Manager.
2. Open Network adapters, and then the Intel(R) xxx properties.
3. On the Teaming tab, select the Team this adapter with other adapters check box.
Click New Team.
4. Type the name of the team in Specify a name for the team and click Next.
5. Include the adapter to the team, and then click Next.
6. Select a team mode, and then click Next.
Tips
The following team types are supported.
− Adapter Fault Tolerance
− Adaptive Load Balancing
− Static Link Aggregation
− Switch Fault Tolerance
7. Click Finish.
8. Click TEAM: "Team name" from the Device Manager, and then open Network adapters to modify the
team.
On the Settings tab, click Modify Team button.
9. Refer to the following procedure to set the team member adapter priority status.
Note
Adapter priority config can be confirmed by the following procedure:
1. Click TEAM: "Team name" from Device manager, and then open Network
adapters.
2. Click Settings and confirm the adapters in team list.
10. On the Settings tab, click Test Switch. Click Run test on the Test Switch screen.
Test completes when a message indicating successful operation is displayed.
Important
Even if the test result is correct, the message below may appear.
Check the setting of the switching hub (L2) port. If no problem is found,
ignore the message.
"The switch is configured with aggregated ports, but the team type does
not support port aggregation. The switch is configured with VLAN tagging,
but the team has no VLANs."
"Reconfigure the switch for link aggregation, or disable VLAN tagging on
the switch."
Note
Before running the test, confirm whether the adapter status is "Active" or "Standby"
on the Settings tab. If any error is displayed, read the message and change the
setting of the switching hub.
11. Confirm the result in Test results.
12. Restart the system.