Installation Guide

4. Setting Up Windows Server 2008 R2
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
157
Chapter 1 Installing Windows
5. When the following message appears, click OK.
6. Eject EXPRESSBUILDER DVD from the optical disk drive, and then restart the system.
Team deletion is now complete.
4.5.4
Setting up team (PROSet)
(1) Team types
The following team types are supported.
z Adapter Fault Tolerance (AFT) is a feature that creates a group containing and automatically converts
the process of the working adapter to the other adapter in the group when any trouble occurred on that
adapter.
z Adaptive Load Balancing (ALB) is a feature that creates a group containing more than one adapter and
enhances the throughput by operating packet transmission from the server by all the adapters. This
feature includes AFT feature.
z Switch Fault Tolerance (SFT) is a feature that provides a failover relationship between two ports when
each port is connected to a separate switch. SFT supports two ports per team.
z Static Link Aggregation (SLA) accounts for the GEC and 802.3ad static protocols. SLA is a
switch-assisted teaming mode and requires configuring ports at both ends of the link: server interfaces
and switch ports.
Note
• Static Link Aggregation (SLA) requires switch support.
• The adapters specified as a group of Adaptive Load Balancing (ALB) can
only be connected to the switching hub.
• Confirm that the setting of the switching hub (L2) port matches the setting of
the server network adapter teaming mode.
• For how to delete an adapter team, refer to Chapter 1 (4.5.4 Setting up team
(PROSet) - (3) Procedure for deleting team).
Check the following points when deleting an adapter team.
− When replacing the motherboard or optional LAN boards after an adapter
team is configured, delete the adapter team first.
− If a team exists, delete the team first. If the team is bound to a Hyper-V virtual
adapter, unbind the Hyper-V adapter before deleting the team.
(2) Setting up team
Important
Possible combinations of network adapters that compose the team are as
follows.
When the number of adapters that composes the team is up to four:
− Between N8104-145 adapters