Installation Guide

4. Setting Up Windows Server 2008 R2
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
130
Chapter 1 Installing Windows
23. Specify the following locations, and then click OK.
(When using EXPRESSBUILDER, select the optical disk drive. When using Internal Flash Memory, select
the volume of INTER-FLASH.)
When using the N8103-149/150/151 RAID Controller:
\001\win\winnt\oemfd\ws2008r2\megasas2
When using the N8103-152 RAID Controller
\001\win\winnt\oemfd\ws2008r2\megasas2
When using the N8103-171 RAID Controller:
\001\win\winnt\oemfd\ws2008r2\megasas2
When using the onboard RAID Controller (LSI Embedded MegaRAID) and a USB-DVD drive:
\001\win\winnt\oemfd\ws2008r2\megasr1
Tips
The driver does not have to be loaded at this time if it was loaded in steps 17 and
18.
24. Select the necessary driver from the driver list shown, and then click Next.
N8103-149/150/151 RAID Controller:
[LSI MegaRAID SAS 9267-8i]
N8103-152 RAID Controller:
[LSI MegaRAID SAS 9265CV-8i]
N8103-171 RAID Controller:
[LSI MegaRAID SAS 9240-8i]
If using the onboard RAID Controller (LSI Embedded MegaRAID) and a USB-DVD drive
[LSI Embedded MegaRAID]
Tips
When N8103-152 is used, the name of the RAID Controller that appears on the
screen differs from the one shown on WebBIOS and Universal RAID Utility.
However, this is not a problem.
25. If you used EXPRESSBUILDER DVD, remove it and then insert the OS installation media.
Tips
If you have not replaced the OS installation media after loading the driver, the
following message may appear.
If it appears, replace the OS installation media, and then click Refresh.
26. When the following window appears, select the disk in which the partition will be created, and then click
Drive options (advanced).
If a partition has already been created, go to step 29.