User Guide

1. Installing Internal Optional Devices
Express5800/R110f-1E User’s Guide
70
Chapter 2 Preparations
If using optional RAID Controller for a 2.5-inch drive model with eight hard disk drives installed (1 to 8
drives)
• You need to prepare the internal SAS/SATA cables K410-240(00) and K410-204(00), which are separately
available.
• Connect the P0 to P3 connectors of the internal SAS/SATA cable K410-240(00) to the SATA0 to SATA3
connectors on the backplane, respectively.
• Connect the P4 to P7 connectors of the internal SAS/SATA cable K410-204(00) to the SATA4 to SATA7
connectors on the backplane, respectively.
• Connect pin 1 (indicated by the triangle Δ) of the S1 connector of the internal SAS/SATA cable
K410-240(00) to pin 1 (indicated by the bold line) of the SGPIO1 connector on the backplane.
• Connect pin 1 (indicated by the triangle Δ) of the S2 connector of the internal SAS/SATA cable
K410-204(00) to pin 1 (indicated by the bold line) of the SGPIO2 connector on the backplane.
• Connect the miniSAS connector of the internal SAS/SATA cable K410-240(00) to the connectors for ports
0 to 3 on the optional RAID Controller.
• Connect the miniSAS connector of the internal SAS/SATA cable K410-204(00) to the connectors for ports
4 to 7 on the optional RAID Controller.
Optional RAID Controller Hard Disk Drive Backplane
SLOT 0 SATA 0
SLOT 1 SATA 1
SLOT 2 SATA 2
Ports 0 to 3
SLOT 3 SATA 3
SLOT 4 SATA 4
SLOT 5 SATA 5
SLOT 6 SATA 6
Ports 4 to 7
SLOT 7 SATA 7