User Guide

1. Installing Internal Optional Devices
Express5800/R110f-1E User’s Guide
63
Chapter 2 Preparations
When configuring a RAID System by using the on-board SATA controller, change the setting of the RAID
configuration jumper.
Jumper on motherboard (SWRAID)
See the figure below for the location of the jumper on the backplane for the hard disk drive when using the
on-board SATA controller.
Backplane for 3.5-inch Hard Disk Drive (J3)
Backplane for 2.5-inch Hard Disk Drive (J3)
After that, configure the RAID System by using the LSI Software RAID Configuration utility.
For details, refer to Chapter 2 (4. RAID System Configuration) in "Maintenance Guide".
Tips
If you setup using the attached EXPRESS BUILDER DVD, the RAID System can
be automatically created.
Motherboard
321
321
Enabled
SWRAID
Disabled
(Default)
Onboard SAT
A
controller
Onboard SATA
controller
N8103-171/149/150/151/
152
N8103-171/149/150/151/
152