User Guide

2. System BIOS Setup
Express5800/R110f-1E User’s Guide
132
Chapter 3 Setup
Category Description To be changed Remark
When the server is supplied
with power from UPS, always
turn on the power.
Server → Power Control Configuration
→ AC-LINK → Power On
If it is turned off by using
POWER switch, leave it OFF
even when UPS supplies power.
Server → Power Control Configuration
→ AC-LINK → Last State
UPS
Powerlink
Keep the power OFF even
when UPS supplies power.
Server → Power Control Configuration
→ AC-LINK → Stay off
Password
If you have set a password, a message prompt you to enter password will be displayed from the next time.
Enter password [ ]
You can attempt password entry up to 3 times. If you entered a wrong password 3 times, operation stops.
(You cannot operate further.) Turn off the power.
Saving changes
If you finish configuration, select Save & Exit and then Save Changes and Exit to save changes and exit.
If you wish to exit without saving the changed parameters, select Save & Exit and then Discard Changes and
Exit.
Or if you wish to restore the setting to default values, select Save & Exit
and then Load Setup Defaults.
(The default value might be different from the factory setting.)