User Guide

2. System BIOS Setup
Express5800/R110f-1E User’s Guide
131
Chapter 3 Setup
2.4
Cases that Require Setting Changes
If you change the BIOS settings shown below, use the SETUP utility to change a parameter which was
configured as factory setting. Other than cases described below, do not change the settings. A list of SETUP
parameters and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category Description To be changed Remark
Change date and time Main → System Date
Main → System Time
Configurable on OS
On/Off NumLock on power ON Boot → Bootup Numlock State
Basic
On/Off the function to display
the NEC logo during POST
Boot → Quite Boot → Disabled By pressing the <Esc> key,
prevent the display of the logo.
Memory Configure the memory after the
DIMM is added or exchanged.
Advanced → Memory Configuration →
Memory Retest → Yes
After rebooting, the Memory
Retest setting changes to No
automatically.
Install RAID Controller board Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings → PCI Slot n Option ROM →
Enabled
n is PCI slot number of the RAID
Controller
Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings → PCI Slot n Option ROM →
Enabled
"n": Slot number in the PCI
device (except for the boot
device)
Optional
board
When an optional board is
installed, set to [Disabled] for
Option ROM for all PCI devices
except for the boot device.
Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings → LAN1 Option ROM Scan →
Disabled
Option ROM on LAN1 must be
disabled.
Change the boot order of
devices
Boot → Boot Option Priorities →
Change the boot priority
Use remote power on function
(from modem)
Advanced → Advanced Chipset
Configuration → Wake On Ring →
Enabled
Use remote power on function
(from RTC alarm)
Advanced → Advanced Chipset
Configuration → Wake On RTC Alarm
→ Enabled
Boot
Control from HW console
terminal
Advanced → Serial Port Configuration
→ Change respective setting.
Set a password to restrict
operation of the SETUP utility.
Security → Administrator Password →
Security → User password
After a password is set, a
message prompting you to enter
the password is displayed when
the SETUP utility is launched
next time.
Security
Set a password to restrict
booting.
Security → Password on Boot →
Enabled
You can select this parameter
after you set a password.