Setup Guide

NEC ESMPRO Manager Ver.5 Setup Guide

CHECK:

 The “LAN2” in “BMC Configuration” screen is displayed only when the managed

component’s BMC supports communication via LAN2. To communicate with the NEC

ESMPRO Manager via LAN2, make the setting on the “LAN2” and “LAN2(Alert)” as

same as “LAN1” and “LAN1(Alert)” .

(8) If you set “Default Gateway”, please connect the managed component via LAN port used by BMC and

the gateway to network.

If you set “Alert Receiver / Management PC IP Address” on same network with the managed

component, please connect the managed component via LAN port used by BMC and the alert

receiver/management PC to network.

Select “Save BMC Configuration” from “BMC Configuration” screen.

The configuration information will be set in the BMC. The MAC addresses of the gateway and the

alert receivers will be also set in the BMC.