Setup Guide

NEC ESMPRO Manager Ver.5 Setup Guide

2.2.3.2 Run NEC EXPRESSBUILDER DOS based with remote console feature

(1) If you set “Default Gateway” at creating the configuration information file, please connect the managed

component via LAN port used by BMC and the gateway to network.

If you set “Alert Receiver / Management PC IP Address” on same network with the managed component at

creating the configuration information file, please connect the managed component via LAN port used by

BMC and the alert receiver/management PC to network.

(2) Configure the BMC of the managed component with the configuration information.

Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive and the “configuration information

FD” into the FD drive on the managed component. And then turn on the component.

After NEC EXPRESSBUILDER DOS based with remote console feature is started and the configuration

information is loaded from the FD into the managed component. The MAC addresses of the gateway and the

alert receivers will be also set in the BMC. And then the Operating System will be rebooted.

TIPS:

 If the setting in the configuration information file is already configured, the managed

component will be not rebooted.

 When the console-less function for LAN connection is used, the BIOS settings are changed

as follows:

Serial Port Address: On Board COM B (only for the managed server supporting SOL)

Baud Rate: 19.2kbps (only for the managed server supporting SOL)

Flow Control : RTS/CTS for the managed server supporting SOL

No Flow for the managed server not supporting SOL

Terminal Type (Console Type) : PC-ANSI (only for the managed server supporting SOL)

To check whether that the managed component supports SOL, see Appendix C. Managed

omponents Summary.

 The managed component is opened the main menu of the NEC EXPRESSBUILDER after

executing the feature.

After registering the managed component on the NEC ESMPRO Manager and confirm the

remote console for the managed component, remove the NEC EXPRESSBUILDER from

the CD-ROM drive if you need.