Setup Guide

NEC ESMPRO Manager Ver.5 Setup Guide
46
<How to stop/start Remote Install service>
Stop:
Stop 3 services. Click “run” from “start” on Windows. Execute following each command:
”net stop BINLSVC”
“net stop TFTPD”
”net stop Groveler”
Start:
(1) Click “control Panel” – “asministrative tool” – ”Active Directory user and computer” from “start”
on Windows.
(2) Find “Remote Install” component computer in the “Active Directory user and computer” snap in
(3) Click the component computer and them click “Property”.
(4) Click “Check component” on the “Remote install” tab.
(5) Follow the instruction of the wizard.
-- About the end of the network-boot procedure of NEC ESMPRO Manager PXE Service.
Do not operate the destination component until network-boot procedure of NEC ESMPRO Manager PXE
Service completes. When you have some operation before that, the NEC ESMPRO Manager PXE Service
cannot be stopped from the NEC ESMPRO Manager.
See2.2.2.4 ”How to confirm the status of the network-boot procedure by NEC ESMPRO Manager PXE
Service”.
--
While the NEC ESMPRO Manager PXE Service is executing the network-boot procedure, the operations
below cannot execute. Please wait until network boot procedure ends.
-- Stop the NEC ESMPRO Manager PXE Service.
-- If you cannot download completely by click “Download of Configuration Information file” on “Linkage
Service” – “Configuration Information”,please change the setting temporarily as following and download
again.
(1) Select “Internet Options” on “Tools” menu of Internet Explorer.
(2) Click the “Security” tab.
(3) Click the “Custom Level”.
(4) Select “Enable” on “Automatic prompting for file downloads”.