Setup Guide

NEC ESMPRO Manager Ver.5 Setup Guide
42
TIPS:
 If a managed server is compatible with SOL and “Enable” is selected for the item
“Redirection (LAN),” the following items necessary for the remote console via the LAN
will be changed automatically.
”Common” screen – “Redirection (WAN/Direct)”: Enable
“WAN/Direct” screen – “Flow Control”: RTS/CTS
(7) Select “LAN1” from “BMC Configuration” screen.
Set the below items. The other items can be used with the default values.
-- “Obtain an IP Address automatically (DHCP)”
Determine whether to dynamically obtain an IP address from a DHCP server.
If the item is set enable and registered, the BMC set the value obtained from DHCP server on “IP
Address”, “Subnet Mask” and “Default Gateway”.
You can set enable on the item only if the BMC supports this capability.
--“IP Address”
Case that BMC on the managed server uses Management LAN port; enter the IP address for the
Management LAN port.
Case that BMC on the managed server uses a standard LAN port; be sure to make the setting
identical to the setting on the operating system of the managed server.
-- “Subnet Mask”
Enter the subnet mask for the IP address.