Setup Guide

NEC ESMPRO Manager Ver.5 Setup Guide
33
2.2 Configure BMC on Managed Component (for LAN
connection)
Configure BMC of the managed component at first.
TIPS:
 This section explains about the minimum setting that is necessary for connection the NEC
ESMPRO Manager with the managed component. For details of BMC configuration, see
document of each tool.
There are three methods for configuring the BMC on a managed component for LAN connection.
 Configuration with NEC ESMPRO Agent Extension ver.1.xx, NEC DianaScope Agent or “System
Management” tool of NEC EXPRESSBUILDER CD-ROM
This section explains the configuration procedure using NEC ESMPRO Agent Extension for Windows.
CHECK:
 There are other BMC configuration tools, but do not use the following tools for setup with
NEC ESMPRO Manager.
-- NEC MWA Agent
-- “System management” started from NEC EXPRESSBUILDER that does not contain
NEC ESMPRO Manager.
 Configuration with NEC ESMPRO Manager PXE Service.
On DHCP server, you can set the configuration of the BMC with NEC ESMPRO Manager PXE
Service.
CHECK:
 NEC ESMPRO Manager PXE Service can be installed only on Windows.
 Configuration with NEC EXPRESSBUILDER DOS based with remote console feature.
NEC EXPRESSBUILDER DOS based with remote console feature is to configure the BMC on the
managed component when a keyboard is not connected.
CHECK:
 Configuration with NEC EXPRESSBUILDER DOS based with remote console feature can
be available only from the NEC EXPRESSBUILDER that contains
NEC ESMPRO Manager.
 See the user’s guide provided with the managed component about NEC
EXPRESSBUILDER DOS based with remote console feature.
If there is the description about NEC EXPRESSBUILDER DOS based with remote console
feature, the feature is available.