User's Guide

1. Installing Internal Optional Devices
Express5800/R110d-1E, E110d-1 User’s Guide
61
Chapter 2 Preparations
Jumper settings on the motherboard or backplane
Change the jumper pin settings as described below.
Jumper pins on the motherboard (SWRAID)
Disabled: 1-2 (default value) / Enabled: 2-3
Set it to Disabled.
SWRAID 設定ジャンパ
Motherboard
321
3 2 1
Disabled Enabled
Backplane for 3.5-inch Hard Disk Drive (J3)
Backplane for 2.5-inch Hard Disk Drive (J3)
Important
The optional RAID Controller is extremely sensitive to static electricity.
Touch metal part of the server such as the frame to discharge static
electricity from your body before handling a RAID Controller. Do not touch
the terminal part or parts of RAID Controller board with bare hands or do not
place the board directly on a desk. For detailed explanation on static
electricity, refer to Chapter 2 (1.2 Anti-static Measures).
Note
When installing an optional RAID Controller, start the BIOS Setup utility, select
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
Onboard SAT
A
controller
Onboard SAT
A
controller