User's Guide

POWER CONSUMPTION CONTROL
You can control the power consumption of the host system through the command line
interface.
The user must have an account as administrator for controlling the
power consumption.
To move the current default target to /admin1/system1, enter the following command at the
command prompt:
cd /admin1/system1
State confirmation and modification of Power Consumption Control
Enter the following command, if you would like to confirm properties related to the power
consumption.
show
Enter the following command if you would like to modify a property related to the power
consumption.
set <Property>=<New value>
The properties related to power consumption on /admin1/system1 are as follows:
• EnabledState
The value is always "2".This specifies whether SSH port is enabled for the
management LAN. This property is read-only.
• oemnec_SafePowerCapping
This specifies whether fault check of the power consumption sensor is enabled. The
valid values for this property are "enabled" and "disabled". "enabled" means that the
fault check is enabled. "disable" means that the fault check is disabled. Default setting
is "disabled".
• oemnec_ExceptionAction_Shutdown_Enable
This specifies whether the shutdown function of the system is enabled when power
consumption control is of no effect within a given oemnec_CorrectionTimeLimit after
the power consumption pass oemnec_PowerCapvalue. The valid values for this
property are "enabled" and "disabled". "enabled" means that the shutdown function is
enabled. "disable" means that the shutdown function is disabled. This is the dynamic
setting. This property is not displayed if oemnec_CriticalPowerCapSensor is disabled.
• oemnec_CorrectionTimeLimit
The shutdown of the system will be done according to setting of
oemnec_ExceptionAction_Shutdown_Enable when power consumption control is of
no effect within a given oemnec_CorrectionTimeLimit (seconds) after the power
consumption pass oemnec_PowerCapvalue. This is the dynamic setting. This property
is not displayed if oemnec_CriticalPowerCapSensor is disabled.
- 84-