User's Guide

MANAGEMENT LAN SETTINGS
You can configure basic setting of management LAN settings of BMC for remote
management using Web server function and command line interface of BMC by using some
tools
• Web Browser
Please refer to Chapter 5 for details.
• BMC Configuration (Off-line)
Press the F4 key during POST(Power on Self test) or displaying logo immediately
after power on or reset the host system to enter the BMC Configuration.
• BMC Configuration (On-line Windows/Linux).
It is possible to install it from NEC EXPRESSBUILDER of the host system
attachment.
The item that can be set with each tool is different. Please refer to help of each tool for
details of a set item.
Setting item
Web Browser Off-line
BMC Configuration
On-line
BMC Configuration Tool
(Windows/Linux)
BMC LAN Setting
Shared LAN Port or
Management LAN Port
NG OK OK
IP Address
Subnet Mask
Default Gateway
DHCP
OK OK OK
Service Settings
HTTP/HTTPS/SSH
OK OK NG
Alert Settings
E-Mail/SNMP
OK OK Only SNMP
User Settings
OK NG NG
Clear BMC Configuration
NG OK OK
Shared BMC LAN
The function for BMC to use operation LAN of the host system is called Shared
BMC LAN.
Select [Enabled] to share a system LAN port with BMC LAN. If you use a
management LAN port for the BMC, select [Disabled]. The management LAN port is
not available when this setting is set [Enabled]. (Default setting is [Enabled]. In
some systems, this menu is not supported. Please refer to the User's Guide of your
host system for more details.)
IP Address
If DHCP is not used to automatically obtain an IP address, enter the BMC’s IP
address.
If DHCP has been used, an automatically obtained IP address will appear.
- 43-