Installation Guide

[Work Around]
If you have changed each item on “Receive from Agen t (TCP/IP)” as user without Administrators privilege,
take the fol lowing procedure:
- Logon as a user with Administrators privilege.
- If you have changed each item from Receive valid (green) to Receive invalid (red), restore it to "Receive
valid (green)", and change it to "Receive invalid (red)" again.
- If you have changed each item from Receive invalid (red) to Receive valid (green), restore it to "Receive
invalid (red)", and change it to "Receive valid (green)" again.
♦Maps to be specified at autodiscovery
After you execute Autodiscover on the Op eration Window, maps may be displayed as if the y were registered i
nfinitely as sh own below:
This problem occurs when a map whose name is the same as its parent map was created at autodiscovery.
In such a c ase, delete the second mapA(*) (in this example) to r esolve the situ ation.
♦Setting a Windows Firewall
If the Windows Firewall is enabled, communication bet ween NEC ESMPRO Manag er and NEC ESMPRO Age
nt will be inter rupted and the system will not work correctly.
To use NEC ESMPRO Manager with the Windows Firewall enabled, open the fo llowing ports:
[Target Ports]
The following table shows the port s for the Windows Firewall to be set on the [Add a Port] di alog box on a
machine on which NEC ESMPRO Manager is inst alled.
Name (can be changed) Port number Protocol Protocol Environment
Inter-Manager communication 8806 TCP When Inter-Manager communication is u
sed.
SNMP Trap 162 UDP When Manager Notification (SNMP) is us
ed (default).
High Reliable Notification 31134 TCP When Manager Notification
(TCP/IP in Ba nd) is used.
Express Notification via Manager 31136 TCP When Express Notification Service is use
d via M anager.
For ports used by NEC ESMPRO Manager, see "Appendix Port numbers / Protoco ls".
66