User's Guide

Setting According to Other Report Receiving Method
2.5.5
Select the setting method from a list in the [Other] property sheet of [Base Setting] dialog and make the
setting in the dialog displayed by pressing the [Configure] button.
Setting of Time Elapses Before Shut Down
 [Shutdown Delay Setting] dialog
– [Shutdown Delay]:
Enter the time that elapses before shut down.
The setting is available in a range of 0 to 60.
Set contents become available immediately after the setting is made.
– [Vanish 'Cancel' button]:
To vanish 'Cancel' button that shut down dialog, mark this check box.
– [Report to Manager, shutting down or rebooting]:
To report to Manager when shut down or rebooting was active, mark this check box.
– [Report to Manager, canceling shutting or rebooting]:
To report to Manager when shut down or rebooting was canceled, mark this check box.
– [OK]:
Set information is added and this dialog box closes.
– [Cancel]:
This dialog box closes with no set information added.
NOTE: If this function status is Red, the server never shut down/reboot even if a
critical event or the shutting down request from the remote Manager has
occurred.
IMPORTANT: If these events occur, the server will shut down.
1. Requested system shutdown from Manager.
2. The temperature exceeds the upper threshold.
3. The temperature is below the lower threshold.
4. Fan unit is malfunctioning.
5. Power unit is malfunctioning.
6. Expansion Chassis major alert reported.
7. The voltage exceeds the upper limit.
8. The voltage below the lower limit.
9. DC Voltage Alert reported.
10. CPU thermal trip occurred.
11. HDD temperature is in error status.
49