User's Guide

For the destination settings, make the following settings.
 [Internet Mail Destination Setting] dialog
– [To]:
Type in the E-mail address (To:) in the form user@domain.
Be sure to divide it with , (comma) when you specify plural addresses (e.g. [e-mail],
[e-mail]).
– [Subject]:
Enter a title of the mail.
– [Message Head]:
To send a message, enter information. Message contents of actual mail consist of this
message header and alert information.
– [Enable]:
Mark this check box when you send mail through Remote Access Service (RAS).
NOTE: Before setting the destination, configure the Remote Access Service.
Additionally, set an entry for the Remote Access Service. If the entry for the
Remote Access Service is not set, this check box cannot be marked.
– [Entry to Use]:
Select a Remote Access Service entry from the list.
38