User's Guide

No base setting is required.

Before setting the destination, make configuration of the Remote Access Service. Additionally set an

entry of the Remote Access Service.

If the entry of the Remote Access Service is not set, no destination setting can be made.

For the destination settings, make the following settings.

 [Manager (TCP/IP Out-of-Band)] dialog

– [IP address (or host name)]:

An IP address (or host name) of the remote Manager is set.

Be sure to specify the IP address of the remote Manager.

NOTE: If the remote Manager to be set has been already set as the trap

destination of the SNMP service, release the setting of the SNMP service.

Exercise care to avoid duplicate settings of the same IP address (or host name)

for the trap destination of the SNMP service after this setting.

If duplicate setting is made, more than one alert will be reported.

– [Entry to Use]:

Select a Remote Access Service entry from the list.

– [User]:

To gain the Remote Access Service, enter a user name of the selected entry.

– [Password]:

To gain the Remote Access Service, enter a password of the selected entry.