User's Guide

 [Manager (TCP/IP In-Band)] dialog
– [IP address (or host name)]:
An IP address (or host name) of the remote Manager is set.
Make sure to specify the IP address of the remote Manager.
NOTE: If the remote Manager to be set has already been specified as the trap
destination of the SNMP service, release the trap destination setting of the SNMP
service.
NOTE: Exercise the care to avoid duplicate setting of the same IP address (or
host name) for the trap destination of the SNMP service after this setting.
If duplicate setting is made, more than one alert will be reported.
– [Port number]:
The port number used for the communication between sockets can be set.
For this number, the same value must be set to the Agent and remote Manager (the default
value is 31134 for both Agent and remote Manager).
Do not change the value as long as the default value works.
IMPORTANT: If the default value does not work, set the port number in the range of 6001
to 65535.
Clicking the [Default] button resets the number to the default value (31134).
If a modification is made, be sure to also modify the setting for the remote manager. This
modification is made in the setting of TCP/IP receive in the [Receive from Agent (TCP/IP)
Setting] dialog of the base setting by executing the Alert Manager setting tool on the server in
which Manager is installed.
– [OK]:
Set information is added and this dialog box closes.
– [Cancel]:
This dialog box closes with no set information added.
– [Test]:
For the test report, press this button.
The test result can be checked by a message.
Manager Report (TCP/IP Out-of-Band)
34