Electronics America Server User Manual

Procedures after Completion of Installation 5-5
IMPORTANT:
 If the community name is changed, the community of NEC ESMPRO
Agent is changed and registered by starting from [Control Panel]. To
change the community to another and register it, use the [SNMP
Community] list box in the [General] tab.
 To allow NEC ESMPRO Agent to receive SNMP packets sent from NEC
ESMPRO Manager, set the send community name in NEC ESMPRO
Manager to be the same as that accepted by the SNMP Service in NEC
ESMPRO Agent.
7. Terminate the network setup.
IMPORTANT:
 During OS installation, if the SNMP service is added to the system after
applying the service package during OS installation, apply it again. If not,
the SNMP service may not operate properly, and this can cause the improper
operation of NEC ESMPRO Agent.
 The SNMP Service is required for operating NEC ESMPRO Agent. If the
SNMP Service is deleted after the installation of NEC ESMPRO Agent,
install the SNMP Service and then reinstall NEC ESMPRO Agent.
 Some software products provided by other vendors use the SNMP Service.
If the SNMP Service and NEC ESMPRO Agent are installed in the system
in which such software as above is installed, it may be impossible to start
NEC ESMPRO Agent services. If so, delete the SNMP Service once and
install the service again. After which, reinstall NEC ESMPRO Agent and the
other vendor's software.