Release Notes

ManualsBrandsNEC ManualsserversNEC Express5800/LE2200

System Release Notes

Server LE2200/MT2200 System Release Notes

These System Release Notes provide the latest available release information.



EtherPower is a trademark of Standard Microsystems Corporation.

NetWare is a registered trademark of Novell, Inc.

SCO is a trademark of The Santa Cruz Operation, Inc.

Windows NT is a registered trademark of Microsoft Inc.

All other trademarks are the property of their respective owners.

Summary of content (6 pages)

PAGE 1
System Release Notes Server LE2200/MT2200 System Release Notes These System Release Notes provide the latest available release information. &RS\ULJKW  3DFNDUG %HOO 1(& ,QF 7UDGHPDUNV EtherPower is a trademark of Standard Microsystems Corporation. NetWare is a registered trademark of Novell, Inc. SCO is a trademark of The Santa Cruz Operation, Inc. Windows NT is a registered trademark of Microsoft Inc. All other trademarks are the property of their respective owners.
PAGE 2
khkh
PAGE 3
1 Introduction These System Release Notes cover the following topics: ■ General ■ Advisories. General The following general comments apply: ■ ■ Versions of the Network Operating Systems tested and recommended are: ■ Windows NT 4.0 Server with Service Pack 3 ■ IntraNetWare 4.11 with Support Pack 2 ■ SCO Open Server 5.04. The current BIOS is: Version 1.00.02.ESP11 ■ The SCSISelect utility is part of the system BIOS in addition to being on the utilities diskette.
PAGE 4
2 BIOS The following advisories apply when using the system BIOS: ■ When booting from the optional RAID, use the SCSISelect Utility to disable the AIC-7880 BIOS as described in the Configuring Your System chapter of your User’s Guide. ■ Pressing F2 to enter Setup after the “Press to enter SETUP” message during boot time is only active while the system BIOS is running, not while the adapter BIOS (i.e., Adaptec or Mylex) is running.
PAGE 5
3 NetWare The following advisories apply when using NetWare: ■ When installing NetWare v4.11, edit the STARTUP.NCF as follows: Change “LOAD MPS14.PSM” to “LOAD MPS14.PSM -A” ■ When installing NetWare 4.11 on servers that use 4 GB SCSI hard drives, you might get a message that there is no DOS partition set to active. This message can be ignored. ■ IDE tape drives are not supported.
PAGE 6
4 SCO The following advisories apply when installing SCO Open Server: ■ IDE tape backups and restores can be done as long as the End of Tape condition is avoided. Appends to the tape are not supported. ■ When installing SCO UNIX 5.04 on a system with an optional RAID, the Adaptec 7880 controller must be disabled using the Resource Configuration Utility (RCU) and the BIOS disabled using the SCSISelect utility (both described in the Configuring Your System chapter of your User’s Guide).