User's Guide

1. Installing Internal Optional Devices

Express5800/GT110e-S User’s Guide

Chapter 2 Preparations

After that, configure the RAID System using LSI Software RAID Configuration Utility.

For details, refer to Chapter 2 (4. RAID System Configuration) in "Maintenance Guide".

Tips

If you use the EXPRESSBUILDER DVD supplied with the server for setup, the

RAID System is automatically configured. Or, you intend to install Windows OS,

OS also can be installed automatically and seamlessly.

(b) If an optional RAID Controller (N8103-128/149/150/151) is used

If using internal Hard Disk Drives in a RAID System with an optional RAID Controller (N8103-128/

149/150/151) installed in the server, the following cable is required instead of using the interface cable

supplied with the server.

− For 3.5-inch Hard Disk Drives: K410-253(00) internal SAS/SATA cable

− For 2.5-inch Hard Disk Drives: K410-180(00) internal SAS cable

Jumper pins on motherboard (SWRAID)

Set to 1-2 (Disabled).

Backplane for 2.5-inch Hard Disk Drive (provided with 2.5-inch models) (J7)

N8103-128/149/150/151: Set to 2-3.

Tips

N8103-128/149/151 and N8103-128/149/150/151 are to be connected for 3.5-inch

Hard Disk Drive model and for 2.5-inch Hard Disk Drive model respectively.

Note

When installing an optional RAID Controller, start the BIOS Setup utility, select

PCI Configuration from the Advanced menu, and then

make sure that the

parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.

Important

Do not change the mode to hibernate when building a RAID System.

N8103-

128/149/150/151

On-board SATA

controller