Maintenance Manual

4. RAID System Configuration
Express5800/GT110e-S Maintenance Guide
84
Chapter 2 Convenient Features
4.2
Menu Tree
: Selection and execution parameter : Setting parameter •: Data display
: Can be set or modified after a virtual drive is created
(1/2)
Menu Description
Configure Specify configuration settings
Easy Configuration Set a configuration using fixed values
New Configuration Set a new configuration
View/Add Configuration Add or view a configuration
Clear Configuration Clear the configuration data
Select Boot Drive Select a virtual drive to be booted
Initialize Initialize the virtual drive
Objects Set up various objects
Adapter Set up the RAID Controller
Sel. Adapter Select an adapter
Rebuild Rate 30
Chk Const Rate 30
FGI Rate 30
BGI Rate 30
Disk WC Off
Read Ahead On
Bios State Enable
Cont on Error Yes
Fast Init Enable
Auto Rebuild On
Auto Resume Enable
Disk Coercion 1 GB
Factory Default Reset to the default values
Virtual Drive Operate a virtual drive
Virtual Drives Select a virtual drive (when multiple virtual drives exist)
Initialize Initialize the virtual drive
Check Consistency Check virtual drive consistency
View/Update Parameters View the virtual drive information
• RAID View the RAID level
• SIZE View the virtual drive capacity
• Stripe SIZE View the stripe size
• #Stripes View the number of Hard Disk Drives in the virtual drive
• State View the virtual drive status
• Spans View the span setting
• Disk WC View the write cache setting
• Read Ahead View the read ahead setting