Maintenance Manual

1. System BIOS
Express5800/GT110e-S Maintenance Guide
73
Chapter 2 Convenient Features
(2/2)
Option Parameter Descriptions
Thermal Sensor
Disabled
[Enabled]
Enable or disable the thermal sensor monitoring
function. If this option is set to Enabled and when
abnormal temperature is detected, the system stops
at the end of POST.
Check previous System Config
[Disabled]
Enabled
If this option is set to Enabled and the system
configuration differs from the previous boot, the
system waits for user’s intervention before booting.
BMC IRQ
[IRQ 11]
Disabled
Specify whether to allocate interrupt lines for BMC
(Baseboard Management Controller).
Post Error Pause
Disabled
[Enabled]
Specify whether to stop the POST once at the end of
POST if an error occurs during the POST.
Memory Error
Halt
[Boot]
Specify whether to stop operation at the end of POST
processing if a memory resource error occurred while
executing POST. This setting is enabled if POST
Error Pause in the Server menu is enabled.
Even if this option is set to Boot, operation stops at
the end of POST if errors occurred for all resources.
Power Switch Inhibit
[Disabled]
Enabled
Enable or disable the power switch inhibit feature.
Standby Power Save
[Disabled]
Enabled
Enable or disable the feature that saves the standby
power on standby. If this option is enabled, the
AC-LINK setting is fixed to Power On and cannot be
changed.
AC-LINK
Stay Off
[Last State]
Power On
Specify how the power state should be when the AC
power is supplied again after loss of power. (See the
table below)
Power On Delay Time Mode
[Manually Setting]
Random
Select a method to specify the delay time before
powering on DC power. Available options are:
"User-specified value" or "random value".
This option is selectable when Power On or Last
State is specified in AC-LINK.
Power ON Delay Time
[xx]-600 Specify the waiting time before powering on DC
within the range between "xx" and 600 seconds.
This feature is enabled when Power On or Last
State is specified in the AC LINK setting.
"xx" indicates the minimum configurable time and is
displayed when executing Load Setup Defaults. If
Save Changes and Exit is selected with a value
smaller than the minimum value specified, the
minimum configurable time is automatically applied.
CLI SETUP
[Disabled]
Enabled
When this option is set to Enabled, the BIOS Setup
utility is run by the CLI SETUP (Command Line
Interface SETUP Menu) instead of the MENU
SETUP. To switch back to the MENU SETUP, set
this option to Disabled in the CLI SETUP menu.
[ ]: Factory setting