Maintenance Manual

9. Offline Tools
Express5800/GT110e-S Maintenance Guide
49
Chapter 1 Maintenance
9.2
Functions of Offline Tools
The offline tools offer the following functions.
Note
When you start the offline tools while RDX is connected to the server, disable RDX
before starting the offline tools by setting RDX to hibernate mode.
• Off-line Maintenance Utility
The Offline Maintenance Utility is started when Maintenance Utility is selected. The Offline Maintenance
Utility is used for preventive maintenance and failure analysis for this product. When you are unable to
start NEC ESMPRO due to a failure, the Offline Maintenance Utility can be used to check the cause of the
failure.
Important
The Off-line Maintenance Utility
is intended for mainenance personnel.
Consult with your service representative if a trouble that requires Off-line
Maintenance Utility occurs.
After starting up the Off-line Maintenance Utility, the following features are available to run.
− IPMI Information Viewer
Displays System Event Log (SEL), Sensor Data Record (SDR), and Field Replaceable Unit (FRU) in
IPMI (Intelligent Platform Management Interface) and also back up such information.
Using this feature, system errors and events can be investigated to locate the parts to be replaced.
You can also clear the System Event Log (SEL) area, and specify the operation when the System Event
Log (SEL) area becomes full.
− System Information Viewer
Displays information on processor (CPU), BIOS.
Also output the information to a text file.
− System Information Management
Set the information specific to your server (Product information, Chassis information).
• BMC Configuration
− It is used for setups of alert functions by BMC (Baseboard Management Controller) and remote control
functions by PC for Management.