Maintenance Manual

7. Resetting and Clearing the Server
Express5800/GT110e-S Maintenance Guide
42
Chapter 1 Maintenance
7.4
Clearing BIOS Settings (CMOS Memory)
To set the BIOS settings back to the factory default settings (clearing CMOS memory), use the internal jumper
switch.
You can also clear the password set in the BIOS Setup utility (SETUP) by using the same procedure.
Tips
When the server works, use the BIOS setup utility (SETUP) to return the settings to
the factory defaults.
To clear the password or the CMOS memory, use the corresponding configuration jumper switch illustrated in
the figure below.
Important
Do not change any other jumper switch settings. Any change may cause the
server to fail or malfunction.
Clear
Protection
3 2 1
Clear
Protection
3 2 1
CMOS clear jumper
(CMOS_CLR)
Password clear jumper
(PASSWORD_CLR)
(Factory Defaults)
(Factory Defaults)