Maintenance Manual

7. Resetting and Clearing the Server
Express5800/GT110e-S Maintenance Guide
41
Chapter 1 Maintenance
7.
Resetting and Clearing the Server
Refer to this chapter when the server does not work or when you set BIOS settings back to the factory settings.
7.1
Software Reset
If the server halts before starting the OS, press <Ctrl> + <Delete> + <Alt> keys. This clears all the data in
progress in memory, and restarts the server.
7.2
BMC RESET
Press BMC RESET Switch only if a problem occurs in EXPRESSSCOPE Engine 3 (BMC).
Do not press BMC RESET Switch in usual operation.
To reset the BMC, press BMC RESET Switch at least five seconds. Remote management feature is disabled
for about 40 seconds after BMC is reset.
Tips
Do not use the BMC RESET (M RESET) when BMC is operating normally.
7.3
Forced Shutdown
Use this function when an OS command does not shut down the server, the POWER switch does not turn off
the server, or software reset does not work.
Continue to hold the POWER switch of the server for at least 4 seconds. The power is forcibly turned off (To
turn the power on again, wait approximately 10 seconds after turning off the power).
Note
If the remote power-on function is used, cycle the power once to load the OS after
the power has been forcibly turned off, and then turn off the power again by
shutting down the OS.
BMC RESET switch