Maintenance Manual

1. POST Error Message
Express5800/GT110e-S Maintenance Guide
118
Chapter 3 Appendix
(2) Error reporting via beep
Even if an error is detected by POST, the error message may be unable to be displayed in the display. In this
case, the computer beeps to report that an error has occurred.
For example, the beep interval 1-3-3-1 indicates 1 beep, a pause, 3 beeps, a pause, 3 beeps, a pause, and 1
beep, which means that an error occurred while checking the memory capacity.
The table below shows the beep code, description, and recommended action.
Beep Code Description Recommended Action
1-3-3-1 No memory could be detected.
An error occurred during a memory capacity
check.
Make sure that the DIMMs are correctly
inserted.
If this does not resolve the problem, contact
your service representative and request either a
DIMM or motherboard replacement.
1-5-2-1 The processor is not installed. Make sure that the processor is correctly
mounted. If this does not resolve the problem,
contact your service representative and request
either a processor or motherboard replacement.
1-1 No graphics controller could be detected. Contact your service representative and request
a motherboard replacement.
1 An error occurred during the POST
processing.
Contact your service representative and request
a motherboard replacement.
3 Failed to read the BIOS executable module.
Or, BIOS has no executable module.
Contact your service representative and request
a motherboard replacement.
4 Failed to initialize the BIOS executable
module.
Contact your service representative and request
a motherboard replacement.
7 Failed to reset the system. Contact your service representative and request
a motherboard replacement.