Maintenance Manual

1. POST Error Message
Express5800/GT110e-S Maintenance Guide
115
Chapter 3 Appendix
(1) Error messages
(1/3)
Error Message Description Recommended Action
8000 System variable is
corrupted.
BIOS setup information is
invalid.
Start the setup utility, and then
execute Load Setup Defaults and
specify the necessary settings. If the
same error continues to occur,
contact your service representative.
8002 Check date and time
settings
The real-time clock time setting
is incorrect.
Start the setup utility, and then specify
the correct date and time. If the same
error continues to occur, contact your
service representative.
8006
System configuration data
cleared by Jumper.
The setup utility settings were
cleared using the jumper.
Follow the procedures described in
Chapter 1 (7. Resetting and Clearing
the Server).
8007
SETUP Menu Password
cleared by Jumper.
The setup utility password was
cleared using the jumper.
8020 BIOS update error.
BIOS update failed. Try BIOS update again. If it fails
again, contact your service
representatives.
9000 Unsupported CPU
detected
An unsupported CPU was
detected.
Contact your service representative.
9E80
Forced to use CPU with
error.
A CPU error occurred.
AE01 DIMM1 has been disabled.
A memory error occurred.
DIMM1 has been disabled.
AE02 DIMM2 has been disabled.
A memory error occurred.
DIMM2 has been disabled.
AE03
DIMM3 has been disabled.
A memory error occurred.
DIMM3 has been disabled.
AE04
DIMM4 has been disabled.
A memory error occurred.
DIMM4 has been disabled.
AE81
DIMM1 with error is
enabled.
An error in DIMM1 occurred, but
because all memory is currently
disabled, this DIMM was forcibly
enabled.
AE82 DIMM2 with error is
enabled.
An error in DIMM2 was detected,
but because all memory is
currently disabled, this DIMM
was forcibly enabled.
B000
Expansion ROM not
initialized
There is no space for expanding
option ROM.
If the board is not used as a boot
device, disable the Option ROM Scan
for that board.
B001
Expansion ROM not
initialized - PCI Slot 1
Option ROM expansion in PCI
slot 1 failed.
If the board is not used as a boot
device, disable the Option ROM Scan
for that board.
B002
Expansion ROM not
initialized - PCI Slot 2
Option ROM expansion in PCI
slot 2 failed.
B003
Expansion ROM not
initialized - PCI Slot 3
Option ROM expansion in PCI
slot 3 failed.
B004
Expansion ROM not
initialized - PCI Slot 4
Option ROM expansion in PCI
slot 4 failed.
B022
Serial Port Configuration
Overlapped.
Overlapping serial port
configuration was detected.
Start up the setup utility, select
Advanced → Serial Port
Configuration, and specify the
setting again in a way that the values
of Base I/O or Interrupt in Serial Port
A and Serial Port B will not be the
same.