Installation Guide

4. Setting Up Windows Server 2008
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
96
Chapter 1 Installing Windows
(4) Set up the partitions.
Confirm settings on the dialog shown below, change them as needed, and then click [Next].
Important
• Partition size
−
Specify a partition size larger than the minimum required for installing
the operating system. (Refer to Chapter 1 (4.1 Before Starting Setup).)
−
The maximum partition size is 2,097,152 MB.
• If you select Create a new partition under Partitioning, the entire contents
of the hard disk drive will be deleted.
• If you select Use the existing partition under Partitioning, data in the first
partition is formatted and deleted. Data in other partitions will be kept. The
figure below shows in which partitions data will be deleted.
First partition
Deleted
Second partition
Retained
Third partition
Retained
•
You cannot reinstall to an existing partition that has been upgraded to a
Dynamic Disk (refer to Chapter 1 (4.1 Before Starting Setup)). Do not select
Use the existing partition under Partitioning.
(5) Enter user information.
Confirm settings on the dialog shown below, change them as needed, and then click [Next].