Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
3. Setting Up Windows Server 2008 R2
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
57
Chapter 1 Installing Windows
5. When the following message appears, Starter Pack installation is complete. Follow the instructions in the
message, and remove EXPRESSBUILDER DVD.
6. Click [OK] and then restart the system.
Installation of Starter Pack is now complete.
3.4.2
When using Internal Flash Memory
(Optional " Internal Flash Memory " is required)
1. After installing the operating system, restart the server.
2. When “Press <F2> Setup, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network” appears during
POST , press <F3> key.
Note
At this time, be sure to remove the DVD from the optical disk drive.
3. When the following message appears, select Os installation *** default ***.
You will automatically advance to the next window, with no need for further input.