Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
3. Setting Up Windows Server 2008 R2
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
54
Chapter 1 Installing Windows
38. Confirm the following according to the settings selected (displayed) in Step 24.
Full installations:
When the Initial Configuration Tasks window appears after you log on, enter the user information.
Server Core installations:
The command prompt will appear. Set the user information.
Tips
For detailed setup procedures, refer to the Microsoft “Step by Step Guide”.
39. Install Starter Pack by referring to Chapter 1 (3.4 Installing Starter Pack).
40. Install drivers and specify detailed settings by referring to Chapter 1 (3.5 Setting Up Device Drivers).
41. For optional devices whose driver has not been installed, install the device drivers according to the
instructions supplied in the driver manual.
42. Apply Service Pack as needed according to Chapter 1 (3.8 Applying Service Pack).
43. Execute setup by following the instructions described in Chapter 1 (7. Setup for Solving Problems).
Setup with OS standard installer is now complete.