Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
3. Setting Up Windows Server 2008 R2
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
51
Chapter 1 Installing Windows
30. If you used EXPRESSBUILDER DVD, remove it and then insert the OS installation media.
Tips
I
f you have not replaced the OS installation media after loading the driver, the
following message may appear.
If it appears, replace the OS installation media, and then click [Refresh].
31. When the following window appears, select the disk in which the partition will be created, and then click
Drive options (advanced).
If a partition has already been created, go to step 34.
32. Click [New], enter the partition size into the size input box, and then click [Apply].
Note
When installing the OS to a disk of over 2,097,152 MB (2 TB), the partition size can
only be set to 2,097,152 MB or less.
Tips
When creating a new partition and installing the OS, a 100 MB boot partition is
created. When the following window appears, click [OK].
33. Select the partition created in step 32, and then click [Format].