Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
3. Setting Up Windows Server 2008 R2
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
50
Chapter 1 Installing Windows
27. “Where do you want to install Windows?” window appears.
Note
If the driver was loaded in steps 22 to 23, or if not using a RAID Controller, go to
step 31.
Click Load Driver.
If the following message appears, replace the OS installation media and EXPRESSBUILDER DVD in the
optical disk drive, and then click [Browse]. Next, go to step 28.
Load Driver
To install the driver needed to access your hard drive, insert
the installation media containing the driver files, and then click
OK.
Note: The installation media can be a floppy disk, CD, DVD, or
USB flash drive.
[Browse] [OK] [Cancel]
Tips
• If using Internal Flash Memory, you do not need to remove the OS installation
media.
• At this time, the message “The Installation media can be a floppy disk, CD,
DVD, or USB flash drive.” appears on the screen, use the supplied
EXPRESSBUILDER DVD or Internal Flash Memory.
28. Specify the following locations, and then click [OK].
(When using EXPRESSBUILDER, select the optical disk drive. When using Internal Flash Memory, select
the volume of INTER-FLASH.)
N8103-128 RAID Controller:
\024\win\winnt\oemfd\ws2008r2\stexstpt
N8103-149/150/151 RAID Controller:
\024\win\winnt\oemfd\ws2008r2\megasas2
If using the onboard RAID Controller (LSI Embedded MegaRAID) and a USB-DVD drive:
\024\win\winnt\oemfd\ws2008r2\megasr1
Tips
The driver does not have to be loaded at this time if it was loaded in steps 22 and
23.
29. Select the necessary driver from the driver list shown, and then click [Next].
When using N8103-128 RAID RAID Controller
[Promise SuperTrak SAS 6G RAID Controller]
When using the N8103-149/150/151 RAID Controller
[LSI MegaRAID SAS 9267-8i]
If using the onboard RAID Controller (LSI Embedded MegaRAID) and a USB-DVD drive
[LSI Embedded MegaRAID]