Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
3. Setting Up Windows Server 2008 R2
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
47
Chapter 1 Installing Windows
18. The server reboots automatically.
If you use Internal Flash Memory, press <F3> key when the following message appears during POST.
Press <F2> Setup, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
Note
Since the OS installation media is set in the optical disk drive in Step 17, boot the
system from the optical disk drive having higher boot priority, not from Internal
Flash Memory.
19. Run from the OS installation media.
If a bootable operating system is already installed on the hard disk drive, press <Enter> key while the
message “Press any key to boot from CD or DVD…” is displayed on the top of the screen.
The boot sequence proceeds and the message “Windows is loading files…” appears.
Note
If “Windows is loading files...” message does not appear, <Enter> key was not
pressed correctly. Reboot and retry.
This step is unnecessary if no bootable operating system exists.
20. When the following window appears, click [Next] at default settings.