Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
3. Setting Up Windows Server 2008 R2
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
44
Chapter 1 Installing Windows
10-1 RAID settings
Use this menu to configure the RAID system with the RAID controller detected automatically.
Note
When using an onboard RAID controller (LSI Embedded MegaRAID):
This function does not support the creation of RAID10 by using the onboard RAID
controller. Refer to Chapter 2 (4. RAID System Configuration) in “Maintenance
Guide”when creating RAID10.
Specify the RAID settings using the RAID settings wizard on Parameter Setup Menu.
When creating new logical drives
(1) Click [Settings] in RAID settings.
(2) Use the wizard to set up logical drives.
Important
If you proceed with wizard, the existing RAID system is destructed and the
contents of hard disk drive will be erased.
When skipping the creation of new logical drives
Click [Skip] in RAID settings.
11. Click [Settings] in Windows settings.