Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
3. Setting Up Windows Server 2008 R2
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
27
Chapter 1 Installing Windows
5. When the Windows PE software license agreement window appears, click [Yes].
Note
Unless you agree these terms, you cannot use EXPRESSBUILDER.
6. Select Set up this computer from Top Menu of EXPRESSBUILDER, and then click [Next].
7. Set parameters on this menu according to your requirement.
When not using parameter file: Go to Step 8.
When using a parameter file: Go to Step 9.
Note
When setting up again, parameter input via the wizard can be omitted by loading
the saved parameter file.
8. If you do not use a parameter file, select an OS from the pull-down menu in [Install Windows], and click
[Next].
On this dialog, select "Windows Server 2008 R2" from the pull-down menu.
→ Go to Step 10.