Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
8. Windows OS Parameter File
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
262
Chapter 1 Installing Windows
When creating new logical drives
(1) Click [Settings] in RAID settings.
(2) Use the wizard to set up the logical drives.
Important
If you proceed with wizard, the existing RAID system is destructed and the
contents of hard disk drive will be erased.
When skipping the creation of new logical drives
Click [Skip] in RAID settings.
Return to the parameter setup menu.
Proceed to Windows setup.
7-2 Windows settings
Set up Windows by using the Windows settings wizard on Parameter Setup Menu.
(1) Click [Settings] in Windows settings.
(2) Click [Next] in the Windows settings wizard.