Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
8. Windows OS Parameter File
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
261
Chapter 1 Installing Windows
7. Set parameters required for setup.
Click [Settings] of the relevant category to change parameters.
Click [Default] if you want to restore the default values.
You can see the default values by clicking [Default
values].
7-1 RAID settings
Use this menu to configure RAID System with the RAID Controller detected automatically.
Note
When using an onboard RAID Controller (LSI Embedded MegaRAID):
This function does not support the creation of RAID10 by using the onboard RAID
Controller. Refer to Chapter 2 (4. RAID System Configuration) in “Maintenance
Guide” when creating RAID10.
Specify the RAID settings using the RAID settings wizard on Parameter Setup Menu.
Important
The number of Physical Devices displayed on the RAID settings wizard is the
upper limit supported by the RAID Controller.
Make sure that the number of actually connected Physical Devices does not
exceed this value.