Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
8. Windows OS Parameter File
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
259
Chapter 1 Installing Windows
8.1.1
How to create a parameter file
This section describes how to specify the setup information necessary for OS installation and how to create
a parameter file.
Follow the procedure described below.
Important
Do not remove EXPRESSBUILDER
DVD from the drive while creating a
parameter file.
Tips
A parameter file can be created when using the following operating systems:
−
Windows Server 2008 R2 (Full installation)
−
Windows Server 2008 (Full installation)
−
Windows Server 2003 x64 Edition, Windows Server 2003
−
Windows 7
−
Windows Vista
−
Windows XP x64 Edition, Windows XP
1. Start the OS.
2. Insert the supplied EXPRESSBUILDER DVD into the optical disk drive.
Autorun Menu automatically appears.
3. Clilck GT110e/GT110e-S/R110e-1E on model selection dialog.
Tips
The dialog shown above may not appear depending on your system environment.
4. Right-click on the window or click Set up Windows to open the short-cut menu.