Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
7. Setup for Solving Problems
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
253
Chapter 1 Installing Windows
8. For the Initial size text box in the Paging file size for selected drive group box, specify a value equal to
or greater than the Recommended value shown in the Total paging file size for all drives area, and
then click [Set].
Note the following when specifying a paging file size.
• The above paging file sizes are recommended for collecting debug information (dump file). The
initial size of the boot volume paging file must be large enough to store dump files. Make sure to
set a sufficient paging file size. If the paging file size is insufficient, correct debug information
might not be able to be collected due to a shortage of virtual memory.
• For details about the Recommended value in the Total paging file size for all drives area, refer
to System partition size in Before Starting Setup.
• When memory is added, re-specify the paging file according to the increased memory size.
9. Click [OK].
The message to restart the system appears depending on the modifications made. In this case, restart
the system.
Specification of the memory dump settings is now complete.