Installation Guide

7. Setup for Solving Problems
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
251
Chapter 1 Installing Windows
9. In the Paging file size for each drive group box, specify as follows:
For the Initial size text box, specify a value equal to or greater than the Recommended value shown in
the Total paging file size for all drives area.
For the Maximum size text box, specify a value equal to or greater than the value specified in the Initial
size text box.
After specifying the above values, click [Set].
Note the following when specifying a paging file size.
• The above paging file sizes are recommended for collecting debug information (dump file).
The initial size of the boot volume paging file must be large enough to store dump files.
Make sure to set a sufficient paging file size. If the paging file size is insufficient, correct
debug information might not be able to be collected due to a shortage of virtual memory.
• For details about the Recommended value in the Total paging file size for all drives area,
refer to System partition size in Before Starting Setup.
• When memory is added, re-specify the paging file according to the increased memory size.
10. Click [OK].
The message to restart the system appears depending on the modifications made.
In this case, restart the system.
Specification of the memory dump settings is now complete.