Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
3. Setting Up Windows Server 2008 R2
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
25
Chapter 1 Installing Windows
3.2.2
Requirements for Setup
Prepare the following media and instruction manuals before starting setup.
Either of the following OS installation media
• NEC operating system installation media (hereafter referred to as Backup DVD-ROM)
• Microsoft operating system installation media (hereafter referred to as Windows Server 2008 R2
DVD-ROM)
First Steps Guide
Either of the following EXPRESSBUILDER
• EXPRESSBUILDER DVD
• Internal Flash Memory (optional)
Prepare if needed:
• Removable media for Windows OS parameter file
• Service Pack
(If the OS installation media contains Service Pack 1, you need not apply the service pack again.)
Tips
• EXPRESSBUILDER may be distributed in Internal Flash Memory.
EXPRESSBUILDER can be run from Internal Flash Memory if it is installed in
the server.
• If you are using a server with Internal Flash Memory installed, you can install the
OS without using EXPRESSBUILDER DVD. .