Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
6. Setting Up Windows Server 2003
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
225
Chapter 1 Installing Windows
Important
The dialog box shown below might appear while installing Starter Pack, but
this does not affect the installation. This dialog box disappears after several
seconds. Do not click [Cancel].
Note
The following progress message appears while Starter Pack is being installed.
Wait a moment until the update is complete. (About 5-10 minutes）
* It changes with states of a system.
When the following message appears, Starter Pack installation is complete.
To apply the Service Pack, click [Yes] and go to step 17.
To not apply the Service Pack, click [No] and go to step 19.
Important
If you are using OS installation media without Service Pack 2, click [Yes].
(Service Pack 2 is mandatory)
If Starter Pack is being reinstalled in an environment where Service Pack 2
has already been installed, you do not need to reinstall Service Pack 2.