Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
6. Setting Up Windows Server 2003
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
216
Chapter 1 Installing Windows
6.3.1
Procedure to apply Windows Server 2003 hotfix: KB921411
(1) When using EXPRESSBUILDER DVD
1. Log on to the system with a user account that has administrative privileges (such as Administrator).
2. Insert EXPRESSBUILDER DVD into the optical disk drive.
If you installed the Windows Server 2003 with Service Pack 2, go to step 9.
3. When the menu appears automatically, close it.
4. Select Run from the Start menu, and then execute the following command:
Optical disk drive:\024\win\winnt\dotnet\qfe\enu\kb921411.exe
5. When the following message appears, click [Next].
After this, continue installation according to the onscreen messages.
6. When the following message appears, click [Finish] and remove EXPRESSBUILDER DVD before
restarting.
7. Log on to the system with a user account that has administrative privileges (such as Administrator).
8. Insert EXPRESSBUILDER DVD into the optical disk drive.