Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
1. Before Starting Setup
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
18
Chapter 1 Installing Windows
1.5
When Using a Mass Storage Controller Not Supported by
EXPRESSBUILDER
To install the Windows when using a mass storage controller not supported by EXPRESSBUILDER (such as
the newest RAID controller), follow the steps below.
You do not need to perform the following instructions usually.
1. Have the instructions for the mass storage controller ready.
Note
If the contents of this document differ from that of the mass storage controller,
prioritize the contents of the controller ’s document.
2. If you use a RAID controller, follow the controller instructions to configure the RAID system.
3. If you want to set up by using EXPRESSBUILDER, go to Step 4.
Refer to (Setup with OS standard installer) section of each OS and click [Skip] in RAID settings.
4. Boot from EXPRESSBUILDER.
5. Select Configure EXPRESSBUILDER settings from Top Menu, and then select Load a driver into
EXPRESSBUILDER. Next, click [Next].
Insert the media in which the driver for the mass storage controller is copied, select the destination, and
then click [Perform].
Tips
By selecting this option, the driver supplied by the CD-ROM or removable media is
loaded, and you can proceed with the EXPRESSBUILDER setup.
6. Setup the server according to "Setup with EXPRESSBUILDER" for each OS.
− Click [Skip] in RAID settings.
− Confirm that Apply drivers for mass storage controller appears under Selected applications in
Application settings.