Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
5. Setting Up Windows Server 2003 R2 x64 Edition
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
178
Chapter 1 Installing Windows
16. Wait for several minutes without attempting any further operation until the following window appears.
Installation of Starter Pack starts when [OK] is clicked.
Important
The dialog box shown below might appear while installing Starter Pack, but
this does not affect the installation. This dialog box disappears after several
seconds. Do not click [Cancel].
Note
The following progress message appears while Starter Pack is being installed.
Wait a moment until the update is complete. (About 5-10 minutes）
* It changes with states of a system.
When the following message appears, Starter Pack installation is complete.